FH36-29S-0.3SHW Ver la hoja de datos (PDF) - HIROSE ELECTRIC

Número de pieza

componentes Descripción

Fabricante

FH36-29S-0.3SHW

0.3 mm Pitch, 1.0 mm above the board Flexible Printed Circuit ZIF Connectors

HIROSE ELECTRIC 

The product information in this catalog is for reference only. Please request the Engineering Drawing for the most current and accurate design information.

FH36 Seriesq0.3 mm Pitch, 1.0 mm above the board Flexible Printed Circuit ZIF Connectors

Precautions

[ Removing of the FPC ]

xRotate the actuator to the fully open position (max. angle of 125ç)

Lift the FPC approximately 10ç (making sure that the positioning tabs clear the protrusions on both sides) and

carefully withdraw it from the connector.

125°

Protrusions for FPC positioning

[ Other Precautions ]

xHand Soldering Precautions

When hand soldering:

1 Do not perform reflow or hand soldering with the FPC inserted in the connector.

2 Do not apply excessive heat or touch the soldering iron anywhere other than the connector leads.

3 Do not use excessive amount of solder or flux compounds.

Operation of the actuator or contacts may be affected by excessive amounts of solder or flux compounds.

®

5-23,OSAKI 5-CHOME,SHINAGAWA-KU,TOKYO 141-8587,JAPAN

PHONE: 81-3-3491-5300, FAX: 81-3-3495-5230

http://www.hirose.com

http://www.hirose-connectors.com

The contents of this catalog are current as of date of 09/2010. Contents are subject to change without notice for the purpose of improvements.

12

Share Link: