EN25P32 Ver la hoja de datos (PDF) - Eon Silicon Solution Inc.

Número de pieza

componentes Descripción

Fabricante

EN25P32

32 Mbit Uniform Sector, Serial Flash Memory

Eon Silicon Solution Inc. 

EN25P32

executed. As soon as Chip Select (CS#) is driven High, the self-timed Sector Erase cycle (whose duration

is tSE) is initiated. While the Sector Erase cycle is in progress, the Status Register may be read to check

the value of the Write In Progress (WIP) bit. The Write In Progress (WIP) bit is 1 during the self-timed

Sector Erase cycle, and is 0 when it is completed. At some unspecified time before the cycle is completed,

the Write Enable Latch (WEL) bit is reset.

A Sector Erase (SE) instruction applied to a page which is protected by the Block Protect (BP2, BP1, BP0)

bits (see Table 3.a and Table 3.b) is not executed.

Bulk Erase (BE) (C7h)

The Bulk Erase (BE) instruction sets all bits to 1 (FFh). Before it can be accepted, a Write Enable

(WREN) instruction must previously have been executed. After the Write Enable (WREN) instruction

has been decoded, the device sets the Write Enable Latch (WEL).

The Bulk Erase (BE) instruction is entered by driving Chip Select (CS#) Low, followed by the instruction

code on Serial Data Input (DI). Chip Select (CS#) must be driven Low for the entire duration of the

sequence.

The instruction sequence is shown in Figure 13.. Chip Select (CS#) must be driven High after the eighth

bit of the instruction code has been latched in, otherwise the Bulk Erase instruction is not executed. As

soon as Chip Select (CS#) is driven High, the self-timed Bulk Erase cycle (whose duration is tBE) is

initiated. While the Bulk Erase cycle is in progress, the Status Register may be read to check the value

of the Write In Progress (WIP) bit. The Write In Progress (WIP) bit is 1 during the self-timed Bulk Erase

cycle, and is 0 when it is completed. At some unspecified time before the cycle is completed, the Write

Enable Latch (WEL) bit is reset.

The Bulk Erase (BE) instruction is executed only if all Block Protect (BP2, BP1, BP0) bits are 0. The Bulk

Erase (BE) instruction is ignored if one, or more, sectors are protected.

This Data Sheet may be revised by subsequent versions 17 ©2004 Eon Silicon Solution, Inc., www.essi.com.tw

or modifications due to changes in technical specifications.

Rev. C, Issue Date: 2007/10/18

Share Link: