EM78P156EL Ver la hoja de datos (PDF) - ELAN Microelectronics
Número de pieza
componentes Descripción
Fabricante
EM78P156EL Datasheet PDF : 55 Pages
| |||
EM78P156EL
OTP ROM
• Bit 7 (OD7) Control bit is used to enable the open-drain of P67 pin.
• IOCC Register is both readable and writable.
7. IOCD (Pull-high Control Register)
7
/PH7
6
/PH6
5
/PH5
4
/PH4
3
/PH3
2
/PH2
• Bit 0 (/PH0) Control bit is used to enable the pull-high of P60 pin.
0: Enable internal pull-high
1: Disable internal pull-high
• Bit 1 (/PH1) Control bit is used to enable the pull-high of P61 pin.
• Bit 2 (/PH2) Control bit is used to enable the pull-high of P62 pin.
• Bit 3 (/PH3) Control bit is used to enable the pull-high of P63 pin.
• Bit 4 (/PH4) Control bit is used to enable the pull-high of P64 pin.
• Bit 5 (/PH5) Control bit is used to enable the pull-high of P65 pin.
• Bit 6 (/PH6) Control bit is used to enable the pull-high of P66 pin.
• Bit 7 (/PH7) Control bit is used to enable the pull-high of P67 pin.
• IOCD Register is both readable and writable.
1
/PH1
0
/PH0
8. IOCE (WDT Control Register)
7
6
5
4
3
2
1
0
WDTE
EIS
-
ROC
-
-
-
-
• Bit 7 (WDTE) Control bit used to enable Watchdog timer.
0: Disable WDT.
1: Enable WDT.
WDTE is both readable and writable.
• Bit 6 (EIS) Control bit is used to define the function of P60 (/INT) pin.
0: P60, bi-directional I/O pin.
1: /INT, external interrupt pin. In this case, the I/O control bit of P60 (bit 0 of IOC6) must be set to "1".
When EIS is "0", the path of /INT is masked. When EIS is "1", the status of /INT pin can also be read
by way of reading Port 6 (R6). Refer to Fig. 7(a).
EIS is both readable and writable.
• Bit 4 (ROC) ROC is used for the R-option.
Setting the ROC to "1" will enable the status of R-option pins (P50∼P51) that are read by the
controller. Clearing the ROC will disable the R-option function. If the R-option function is selected,
user must connect the P51 pin or/and P50 pin to VSS with a 430KΩ external resistor (Rex). If the
Rex is connected/disconnected, the status of P50 (P51) is read as "0"/"1". Refer to Fig. 8.
This specification is subject to change without prior notice.
14
07.29.2004 (V1.3)
Share Link: 