RF2371 Ver la hoja de datos (PDF) - RF Micro Devices

Número de pieza

componentes Descripción

Fabricante

RF2371

3V LOW NOISE AMPLIFIER

RF Micro Devices 

RF2371

Preliminary

Application Information

The RF2371 may be configured to use either the internal current setting or the external current setting. This choice is

made by asserting IPSET, pin 4, to CMOS level “low” for the internal current setting or CMOS level “high” for the external

current setting.

Internal Current Setting

When IPSET is set to CMOS “low”, the internal current settings are chosen. This current draw is typically 2.9mA. In this

mode, the resistorR1 may be removed from the evaluation board schematic and ISET left floating. The condition for opti-

mal IP3 is to use the internal current setting option and leave the ISET pin open (no connect).

4

External Current Setting

The external current setting is configured by using the series resistor between ISET, pin7, and ground (refer to resistor

R1 in evaluation board schematic). The value of the resistor may be changed to permit various operating currents up to a

maximum allowable current of 20mA. The table below gives approximate minimum R1 values to allow the 20mA maxi-

mum current draw at various operating voltages.

Note: When the internal current setting was selected, the part tested drew 4.4mA, which is higher than typical

(2.9mA). Thus values of R1 given vary from part to part.

VCC (V)

Resistor R1 (Ω)

Current Draw (mA)

2.7

2.4 k

20.1

3.0

2.7 k

20.1

3.3

3.0 k

20.0

3.6

3.3 k

19.8

4-224

Rev A2 010205

Share Link: