ATMEGA6450-16AI(2004) Ver la hoja de datos (PDF) - Atmel Corporation
Número de pieza
componentes Descripción
Fabricante
ATMEGA6450-16AI Datasheet PDF : 347 Pages
| |||
ATmega325/3250/645/6450
When this Oscillator is selected, start-up times are determined by the SUT Fuses as
shown in Table 10 on page 29.
Table 10. Start-up times for the internal calibrated RC Oscillator clock selection
Power Conditions
BOD enabled
Fast rising power
Slowly rising power
Start-up Time from Power-
down and Power-save
6 CK
6 CK
6 CK
Reserved
Additional Delay from
Reset (VCC = 5.0V)
14CK(1)
14CK + 4.1 ms
14CK + 65 ms(2)
SUT1..0
00
01
10
11
Note:
1. If the RSTDISBL fuse is programmed, this start-up time will be increased to
14CK + 4.1 ms to ensure programming mode can be entered.
2. The device is shipped with this option selected.
Oscillator Calibration Register
– OSCCAL
Bit
Read/Write
Initial Value
7
CAL7
R/W
6
CAL6
R/W
5
4
3
2
CAL5
CAL4
CAL3
CAL2
R/W
R/W
R/W
R/W
Device Specific Calibration Value
1
CAL1
R/W
0
CAL0
R/W
OSCCAL
• Bits 7..0 – CAL7..0: Oscillator Calibration Value
The Oscillator Calibration Register is used to trim the Calibrated Internal RC Oscillator
to remove process variations from the oscillator frequency. The factory-calibrated value
is automatically written to this register during chip reset, giving an oscillator frequency of
8.0 MHz at 25°C. The application software can write this register to change the oscillator
frequency. The oscillator can be calibrated to any frequency in the range 7.3 - 8.1 MHz
within ±1% accuracy. Calibration outside that range is not guaranteed.
Note that this oscillator is used to time EEPROM and Flash write accesses, and these
write times will be affected accordingly. If the EEPROM or Flash are written, do not cali-
brate to more than 8.8 MHz. Otherwise, the EEPROM or Flash write may fail.
The CAL7 bit determines the range of operation for the oscillator. Setting this bit to 0
gives the lowest frequency range, setting this bit to 1 gives the highest frequency range.
The two frequency ranges are overlapping, in other words a setting of OSCCAL = 0x7F
gives a higher frequency than OSCCAL = 0x80.
The CAL6..0 bits are used to tune the frequency within the selected range. A setting of
0x00 gives the lowest frequency in that range, and a setting of 0x7F gives the highest
frequency in the range. Incrementing CAL6..0 by 1 will give a frequency increment of
less than 2% in the frequency range 7.3 - 8.1 MHz.
External Clock
To drive the device from an external clock source, XTAL1 should be driven as shown in
Figure 14. To run the device on an external clock, the CKSEL Fuses must be pro-
grammed to “0000”.
29
2570A–AVR–09/04
Share Link: 