ATA6662 Ver la hoja de datos (PDF) - Atmel Corporation

Número de pieza

componentes Descripción

Fabricante

ATA6662

LIN Transceiver

Atmel Corporation 

9. Revision History

Please note that the following page numbers referred to in this section refer to the specific revision

mentioned, not to this document.

Revision No.

History

• Features on page 1 changed

4916O-AUTO-05/10

• Heading 3.6: text changed

4916N-AUTO-03/10

• Features on page 1 changed

• Section 4 “Absolute Maximum Ratings” on page 9 changed

• Section 6 “Electrical Characteristics” number 7.13 on page 11 added

• Section 7 “Ordering Information” on page 16 changed

4916M-AUTO-09/09

• Figure 1-1 “Block Diagram” on page 1 changed

• Section 4 “Absolute Maximum Ratings” on page 8 changed

• Figure 6-2 “Application Circuit” on page 14 changed

4916L-AUTO-02/09 • Section 6 “El.Characteristics” numbers 3.2 and 4.2 on page 9 changed

4916K-AUTO-12/08

• Figure 2-1 “Pinning SO8” on page 2 changed

• Section 3.2 “Supply Pin (VS)” on page 3 changed

• Section 3.8 “Enable Input Pin (EN)” on page 4 changed

• Section 3.11 “Operation Modes” on page 5 changed

• Section 3.12 “Remote Wake-up via Dominant Bus State” on page 5 changed

• Section 3.14 “Wake-up Source Recognition” on page 6 changed

• Figure 3.2 “LIN Wake-up Waveform Diagram” on page 7 changed

• Figure 3.3 “Wake-up from Wake-up Switch” on page 7 changed

• Section 4 “Absolute Maximum Ratings” on page 8 changed

• Section 5 “Thermal Resistance” on page 8 changed

• Section 6 “Electrical Characteristics” on pages 9 to 12 changed

• Figure 6-2 “Application Circuit” on page 13 changed

4916J-AUTO-02/08

• “Pre-normal Mode” in “Fail-safe Mode” changed

• Section 3.9 “Inhibit Output Pin (INH) on page 4 changed

• Section 4 “Absolute Maximum Ratings” on page 8 changed

• Section 6 “Electrical Characteristics” number 5.1 on page 9 changed

4916I-AUTO-12/07

• Section 3.1 “Physical Layer Compatibility” on page 3 added

• Section 6 “El.Characteristics” numbers 1.5, 1.6 and 1.7 on page 9 changed

4916H-AUTO-10/07 • Section 7 “Ordering Information” on page 14 changed

4916G-AUTO-07/07 • Put datasheet in a new template

• Capital T for time generally changed in a lower case t

16 ATA6662

4916O–AUTO–05/10

Share Link: