ATA6612 Ver la hoja de datos (PDF) - Atmel Corporation

Número de pieza

componentes Descripción

Fabricante

ATA6612

Microcontroller with LIN Transceiver, 5V Regulator and Watchdog

Atmel Corporation 

ATA6612/ATA6613

13. Revision History

Please note that the following page numbers referred to in this section refer to the specific revision

mentioned, not to this document.

Revision No.

History

9111G-AUTO-05/10

• Table 2-2 “Maximum Ratings of the SiP” on page 4 changed

• Section 3.1 “Features” on page 5 changed

• Section 3.2 “Description” on page 5 changed

• Section 3.3.1 “Physical Layer Compatibility” on page 7 changed

• Section 3.3.6 “Bus Pin LIN” on page 7 changed

• Section 3.3.8 “TX Dominant Time-out Function” on page 8 changed

• Section 3.3.10 “Enabel Input Pin (EN)” on page 8 changed

• Section 3.3.14 “KL_15 Pin” on page 9 changed

• Section 3.3.20 “Modes of Operation” on pages 10 to 14 changed

• Section 3.3.21 “Wake-up Scenarios from Silent to Sleep Mode on page

15 changed

• Section 3.3.23 “Voltage Regulator” on page 16 changed

• Section 6 “Electrical Characteristics” on page 23 changed

• Section 7.7.7.1 “Power Reduction Register” on page 66 changed

9111F-AUTO-12/08

• Section 11 “Errata” on page 360 changed

9111E-AUTO-07/08

• Table 2-2 “Maximum Ratings of the SiP” on page 4 changed

• Section 4 “Absolute Maximum Ratings” on page 20 changed

• Figure 8-1 “Typical LIN Slave Application” on page 355 changed

• Figure 8-2 “Typical LIN Master Application” on page 356 changed

• Figure 8-3 “LIN Slave Application with Minimum External Components”

on page 357 changed

• Figure 8-4 “Typical LIN Master Application LIN Master Pull-up Switched

Off during Sleep Mode” on page 358 added

9111D-AUTO-06/08

• Figure 3-1 “Block Diagram” on page 6 changed

• Section 3.3 “Functional Description” on pages 7 to 18 changed

• Section 6.5.3.2 “The EEPROM Address Register – EEARH and EEARL”

on page 45 changed

9111C-AUTO-02/08

• Figure 8-2 “Typical LIN Master Application” on page 356 changed

9111B-AUTO-11/07

• Section 5 “Electrical Characteristics” on pages 21 to 26 changed

• Section 6.6.6 “Calibrated Internal RC Oscillator” on page 57 changed

• Figure 8-3 “LIN Slave Application with Minimum External Components

on page 357 added

9111G–AUTO–05/10

361

Share Link: