AS1536-BSOT Ver la hoja de datos (PDF) - austriamicrosystems AG

Número de pieza

componentes Descripción

Fabricante

AS1536-BSOT

12-Bit, Single Supply, Low-Power, 73ksps A/D Converters

austriamicrosystems AG 

AS1536/AS1537

Datasheet - Application Information

Unlike the SPI interface, which requires two 1-byte reads to acquire the 12 data bits from the AS1536/AS1537, QSPI

allows the minimum number of clock cycles necessary to clock in the data. The devices require 13 clock cycles from

the microprocessor to clock out the 12 data bits with no trailing zeros (see Figure 36).

Note: The maximum clock frequency to ensure compatibility with QSPI is 2.097MHz.

Figure 36. QSPI Serial Interface Timing (CPOL = CPHA = 0)

SCLK

CSN

tCONV

DOUT

EOC

D11 D10 D9 D8 D7 D6 D5 D4 D3 D2 D1 D0

MSB

LSB

High-Z

when CSN

is High

Layout Considerations

The AS1536/AS1537 require proper layout and design procedures for optimum performance.

! Use printed circuit boards; wirewrap boards should not be used.

! Separate analog and digital traces from each other. Analog and digital traces should not run parallel to each other

(especially clock traces).

! Digital traces should not run beneath the AS1536/AS1537.

! Use a single-point analog ground at GND, separate from the digital ground (see Figure 37). Connect all other ana-

log grounds and DGND to this star ground point for further noise reduction. No other digital system ground should

be connected to this single-point analog ground. The ground return to the power supply for this ground should be

low impedance and as short as possible for noise-free operation.

! High-frequency noise in the VDD power supply may affect the AS1536/AS1537 high-speed comparator. Bypass

this supply to the single-point analog ground with 0.1µF and 4.7µF bypass capacitors (see Figure 37). The bypass

capacitors should be placed as close to the device as possible for optimum power supply noise-rejection. If the

power supply is very noisy, a 10Ω resistor can be connected as a low-pass filter to attenuate supply noise.

Figure 37. Recommended Ground Design

+3V

Power

Supplies

GND

GND

10Ω 4.7µF

(Optional)

+

+3V

+3V

DGND

Digital

Circuitry

5

GND

0.1µF

1

VDD

AS1536/

AS1537

www.austriamicrosystems.com

Revision 1.01

19 - 22

Share Link: