EVAL-CED1Z(Rev0) Ver la hoja de datos (PDF) - Analog Devices

Número de pieza

componentes Descripción

Fabricante

EVAL-CED1Z
(Rev.:Rev0)

1 MSPS, 12-Bit, Simultaneous Sampling SAR ADC with PGA and Four Comparators

Analog Devices 

REFERENCE

The AD7262/AD7262-5 can operate with either the internal

2.5 V on-chip reference or an externally applied reference. The

logic state of the REFSEL pin determines whether the internal

reference is used. The internal reference is selected for both ADCs

when the REFSEL pin is tied to logic high. If the REFSEL pin is

tied to AGND, an external reference can be supplied through

the VREFA and/or VREFB pins. On power-up, the REFSEL pin

must be tied to either a low or high logic state for the part to

operate. Suitable reference sources for the AD7262/AD7262-5

include AD780, AD1582, ADR431, REF193, and ADR391.

The internal reference circuitry consists of a 2.5 V band gap

reference and a reference buffer. When the AD7262/AD7262-5

are operated in internal reference mode, the 2.5 V internal

reference is available at the VREFA and VREFB pins, which should

be decoupled to AGND using a 1 μF capacitor. It is recommended

that the internal reference be buffered before applying it elsewhere

in the system. The internal reference is capable of sourcing up

to 90 μA of current when the converter is static. If the internal

reference operation is required for the ADC conversion, the

REFSEL pin must be tied to logic high on power-up. The refer-

ence buffer requires 240 μs to power up and charge the 1 μF

decoupling capacitor during the power-up time.

AD7262

TYPICAL CONNECTION DIAGRAMS

Figure 26 and Figure 27 are typical connection diagrams for the

AD7262/AD7262-5. In these configurations, the AGND pin is

connected to the analog ground plane of the system, and the

DGND pin is connected to the digital ground plane of the system.

The analog inputs on the AD7262/AD7262-5 are true differen-

tial and have an input impedance in excess of 1 GΩ; thus, no

driving op amps are required. The AD7262/AD7262-5 can operate

with either an internal or an external reference. In Figure 26, the

AD7262/AD7262-5 are configured to operate in control register

mode; thus, G0 to G3, PD1, and PD2 can be connected to ground

(low logic state). Figure 27 has the gain pins configured for a gain

of 2 setup; thus, the device is in pin-driven mode. Both circuit

configurations illustrate the use of the internal 2.5 V reference

The CA_CBVCC and the CC_CDVCC pins can be connected to either

a 3 V or a 5 V supply voltage. The AVCC pin must be connected

to a 5 V supply. All supplies should be decoupled with a 100 nF

capacitor at the device pin, and some supply sources may require a

10 μF capacitor where the source is supplied to the circuit board.

The VDRIVE pin is connected to the supply voltage of the micro-

processor. The voltage applied to the VDRIVE input controls the

voltage of the serial interface. VDRIVE can be set to 3 V or 5 V.

Rev. 0 | Page 17 of 32

Share Link: