29LV160TE Ver la hoja de datos (PDF) - Fujitsu

Número de pieza

componentes Descripción

Fabricante

29LV160TE

FLASH MEMORY CMOS 16M (2M × 8/1M × 16) BIT

Fujitsu 

MBM29LV160TE/BE-70/90/12

written during the Chip Erase operation or Embedded Program Algorithm. Writting the Erase Suspend command

during the Sector Erase time-out results in immediate termination of the time-out period and suspension of the

erase operation.

Writing the Erase Resume command resumes the erase operation. The addresses are “DON’T CARES” when

writing the Erase Suspend or Erase Resume commands.

When the Erase Suspend command is written during the Sector Erase operation, the device will take a maximum

of “tSPD” to suspend the erase operation. When the devices have entered the erase-suspended mode, the

RY/BY output pin and the DQ7 bit will be at logic “1”, and DQ6 will stop toggling. The user must use the address

of the erasing sector for reading DQ6 and DQ7 to determine if the erase operation has been suspended. Further

writes of the Erase Suspend command are ignored.

When the erase operation has been suspended, the device defaults to the erase-suspend-read mode. Reading

data in this mode is the same as reading from the standard read mode except that the data must be read from

sectors that have not been erase-suspended. Successively reading from the erase-suspended sector while the

device is in the erase-suspend-read mode will cause DQ2 to toggle. (See the section on DQ2.)

After entering the erase-suspend-read mode, the user can program the device by writing the appropriate com-

mand sequence for Program. This Program mode is known as the erase-suspend-program mode. Again, pro-

gramming in this mode is the same as programming in the regular Program mode except that the data must be

programmed to sectors that are not erase-suspended. Successively reading from the erase-suspended sector

while the devices are in the erase-suspend-program mode will cause DQ2 to toggle. The end of the erase-

suspended Program operation is detected by the RY/BY output pin, Data polling of DQ7, or the Toggle Bit (DQ6)

which is the same as the regular Program operation. Note that DQ7 must be read from the Program address

while DQ6 can be read from any address.

To resume the operation of Sector Erase, the Resume command (30H) should be written. Any further writes of

the Resume command at this point will be ignored. Another Erase Suspend command can be written after the

chip has resumed erasing.

20

Share Link: