CSA3.84MG Ver la hoja de datos (PDF) - Hynix Semiconductor

Número de pieza

componentes Descripción

Fabricante

CSA3.84MG

4-BIT SINGLE CHIP MICROCOMPUTERS

Hynix Semiconductor 

Chapter 5. Software

SET (SETUP)

[Function]

To setup the operating mode for the simulator.

[Format]

SET_c_xã

[Explanation]

This is used to setup the simulator.

The following commands can be executed with this command.

• When setting symbols for Assembler and Unassembler.

SET L x ã

Here, the range of X is defined as in the below.

0 : Symbol shall be used. (Default)

1 : Symbol shall not be used.

• SET PO x ã

0 : When I/O WRITE command is executed while executing G command, no

display shall be mode. (Default)

1 : When I/O WRITE command is executed while executing G command, the

values in the event shall be displayed on CRT screen.

2 : When I/O WRITE command is executed while executing G command, the

values in the event shall be displayed on CRT screen and the operating

shall be stopped.

• SET PI x ã

0 : In case I/O READ command is to be executed while simulating, the

system reads the value set on the port input register. The port input

register setting is to be performed with `R` command.

1 : In case I/O READ command is to be executed while simulating, the

system stops before the execution.

In this case, set the value on the port input register.

2 : Value is set on the port input register from I/O file (PORT.DAT).

The file is opened when this command is executed and the file shall not be

reread. If there is no I/O file, error shall be issued.

5 - 36

Share Link: