CHV2242A Ver la hoja de datos (PDF) - United Monolithic Semiconductors

Número de pieza

componentes Descripción

Fabricante

CHV2242A

Q-band VCO based on Ku-band Oscillator and Q-band Multiplier

United Monolithic Semiconductors 

CHV2242a

Typical Assembly and Bias Configuration

V-tune

DC and control lines

-V

+V

>= 120pF

Q-band VCO

µ-strip line

L_erc1

L_erc2

µ-strip line

L_out

µ-strip line

This drawing shows an example of assembly and bias configuration. All the

transistors are internally self biased. The positive and negative voltages can be

respectively connected together (see drawing) according to the recommended

values given in the electrical characteristics table. Due to the high value of

frequency sensitivity versus tuning voltage (around 500MHz/V), the signal

applied to V_tune port must have very low level of noise.

For the RF pads the equivalent wire bonding inductance (diameter=25µm) has to

be according to the following recommendation.

Port

ERC1 (2)

ERC2 (19)

RF_out (16)

Equivalent inductance

(nH)

L_erc1 = 0.4

L_erc2 = 0.4

L_out = 0.28

Approximated wire

length (mm)

0.5

0.5

0.35

For a micro-strip configuration a hole in the substrate is recommended for chip

assembly.

Ref. : DSCHV22421074 -15-Mar.-01

4/8

Specifications subject to change without notice

Route Départementale 128 , B.P.46 - 91401 ORSAY Cedex - FRANCE

Tel.: +33 (0)1 69 33 03 08 - Fax : +33 (0)1 69 33 03 09

Share Link: